![]() ![]() ![]() Using a ruler or a tape measure means you are automatically inducing some error because you must interpolate your reading to the nearest etch line, then translate that onto your stock. When you can, show the stock you are going to cut to the work and make your marks on the stock. I find ruler stops help significantly when taking measurements.Īnything over 12-inches I reach for my tape measure. I also use ruler stops (I use woodpecker ruler stops but there a lot of others out there) that fit on my steel rulers. I use my 6-inch steel ruler for measurements less than 6-inches. For me this means that when measuring anything under 12-inches I reach for my steel ruler. Your steel ruler will give you more accurate results than your tape measure, so use it when you can. It is supposed to move, but it can get worn out over time and move too much. Additionally, I find that tape measures are the most likely to go out of accuracy so check them often. I find it helps significantly to purchase rulers and tape measures from the same manufacturer. Get rid of the ones that do not measure up. Check all your rulers and tape measures against this standard. Use this ruler as your shop standard and make sure all your other measuring tools match it. If you have a high-quality combination square such as a PEC or a Stanley you can use it’s ruler, but I find it more convenient not to remove the ruler from the head of my combination square when I need a ruler so I have a high quality, thick steel ruler from PEC. You should have at least one high quality, 12-inch steel rule that is thick and finely etched. Tip #1: Use Accurate Rulers and Measuring tapes. 10 Tips for Better Precision in your Woodworking ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |